tailieunhanh - Standard Specification for Nickel and Nickel-Base Alloy-Clad Steel Plate

"Standard Specification for Nickel and Nickel-Base Alloy-Clad Steel Plate" covers plate of a carbon steel or low-alloy steel base to which is integrally and continuously bonded on one or both sides a layer of nickel or nickel-base alloy. The material is generally intended for pressure vessel use but may be used in other structural applications where corrosion resistance of the alloy is of prime importance. | Designation A265 12 Standard Specification for Nickel and Nickel-Base Alloy-Clad Steel Plate1 This standard is issued under the fixed designation A265 the number immediately following the designation indicates the year of original adoption or in the case of revision the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the . Department of Defense. 1. Scope Molybdenum Alloy UNS N06617 and Nickel-Iron- 2 This specification covers plate of a carbon steel or Chromium-Tungsten Alloy UNS N06674 Plate Sheet low-alloy steel base to which is integrally and continuously and Strip bonded on one or both sides a layer of nickel or nickel-base B333 Specification for Nickel-Molybdenum Alloy Plate alloy. The material is generally intended for pressure vessel use Sheet and Strip but may be used in other structural applications where corro- B409 Specification for Nickel-Iron-Chromium Alloy Plate sion resistance of the alloy is of prime importance. Sheet and Strip B424 Specification for Ni-Fe-Cr-Mo-Cu Alloy UNS The values stated in inch-pound units are to be regarded N08825 UNS N08221 and UNS N06845 Plate Sheet as standard. The values given in parentheses are mathematical and Strip conversions to SI units that are provided for information only B443 Specification for Nickel-Chromium-Molybdenum- and are not considered standard. Columbium Alloy UNS N06625 and Nickel-Chromium- Molybdenum-SiliconAlloy UNS N06219 Plate Sheet 2. Referenced Documents and Strip ASTM Standards 3 B463 Specification for UNS N08020 Alloy Plate Sheet and A6 A6M Specification for General Requirements for Rolled Strip Structural Steel Bars Plates Shapes and Sheet Piling B575 Specification for Low-Carbon Nickel-Chromium- A20 A20M Specification for General Requirements for Steel Molybdenum Low-Carbon Nickel-Chromium- Plates for .