tailieunhanh - Standard Specification for Stainless Chromium Steel-Clad Plate

"Standard Specification for Stainless Chromium Steel-Clad Plate" covers plate of a carbon steel or low-alloy steel base to which is integrally and continuously bonded on one or both sides a layer of stainless chromium steel. The material is generally intended for pressure vessel use. | Designation A263 12 Standard Specification for Stainless Chromium Steel-Clad Plate1 This standard is issued under the fixed designation A263 the number immediately following the designation indicates the year of original adoption or in the case of revision the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the . Department of Defense. 1. Scope Other Standards 2 This specification covers plate of a carbon steel or ASME Boiler and Pressure Vessel Code Section IX4 low-alloy steel base to which is integrally and continuously 3. Terminology bonded on one or both sides a layer of stainless chromium steel. The material is generally intended for pressure vessel Definitions of Terms Specific to This Standard use. This material is considered as single-clad or double- clad stainless chromium-steel plate depending on whether one The values stated in inch-pound units are to be regarded or both sides are covered. as standard. The values given in parentheses are mathematical alloy cladding the stainless chromium steel compo- conversions to SI units that are provided for information only nent of the composite plate. and are not considered standard. base metal backing steel component to which the 2. Referenced Documents alloy cladding is applied usually the greater percentage of the composite plate. ASTM Standards 3 A6 A6M Specification for General Requirements for Rolled integrally and continuously bonded a condition in Structural Steel Bars Plates Shapes and Sheet Piling which the alloy cladding and base metal are brought together to A20 A20M Specification for General Requirements for Steel form a metallurgical bond at essentially the entire interface of Plates for Pressure Vessels the two metals by means other than those processes that do not A240 A240M .