Đang chuẩn bị liên kết để tải về tài liệu:
Dynamic Modeling using UniSim Design: Unit 1 - Getting Started in Steady State

Đang chuẩn bị nút TẢI XUỐNG, xin hãy chờ

Unit 1 "Getting Started in Steady State" of lectures Dynamic Modeling using UniSim Design presented on specific instructions detailing the steps, the use UniSim Design models, starting in Steady State. Invite you to refer to the lecture content more documents serving the academic needs and research. | Nhóm Mô phỏng Công nghệ Hoá học và Dầu khí Trường Đại học Bách khoa Hà Nội .BKSIM Dynamic Modeling using UniSim Design Unit 1 Getting Started in Steady State New case Tab Fluid pkgs PR Name Oil Gas Plant Components Nitrogen CO2 Methane Ethane Propane i-butane n-butane i-pentane n-pentane n-hexane H2O .BKSIM 2 New case .BKSIM

TÀI LIỆU LIÊN QUAN

Dynamic modeling using unisim design: Unit 5 - Dynamic details

Dynamic modeling using unisim design: Unit 8 - TEG Dehydration Tower

Dynamic modeling using unisim design: Unit 10 - Cause and effect matrix

Dynamic Modeling using UniSim Design: Unit 1 - Getting Started in Steady State

Dynamic modeling using unisim design: Unit 2 - Pressure flow theory

Dynamic modeling using unisim design: Unit 3 - Transitioning from steady state to dynamics

Dynamic modeling using unisim design: Unit 4 - Basis control theory

Dynamic modeling using unisim design: Unit 6 - Expanding the model

Dynamic modeling using unisim design: Unit 7 - Compresor

Dynamic modeling using unisim design: Unit 9 - Event sheduler