Đang chuẩn bị liên kết để tải về tài liệu:
How to design a car audio system!

This section deals with "cosmetic" rust repairs, on panels that do not form part of the vehicles load-bearing structure. Any repairs to chassis, frame or mounting points of any type must be carried out to a professional standard, which is not the intended scope of this section. Rust repairs generally cover two areas; surface rust and rust holes (perforation ) Surface rust can usually be removed and held at bay successfully, perforated metalwork will need much more extensive work to provide a lasting repair. Where surface rust and pitting is evident, additional stages to the normal sanding/feathering process are. | How to design a car audio system Since the beginning of car Audio the design for systems has not changed. The quality of audio components has gotten way better but the general idea on good systems has not changed. I will lay out 3 systems for you. The first system is the basic system. This is one of the most common system designs and you can get your car sounding incredible for not much money The items you need for this system are as follows. A good Stereo up front with enough power to run all of the interior speakers. A good set of Front Speakers or Component set. A good set of rear speakers A good amplifier A good subwoofer This layout is standard for any vehicle and depending on how good you want your system to be will determine how good your vehicle will sound. The rule is You get what you pay for Note that Component set consists of a midrange and tweeter combination. The tweeter will tap off of the midrange. Good Component sets will come with a passive crossover network that is included with the set. If the Component Set does not include a cross over then you should choose a different set that has one Note that the Crossover that comes with the component set will send the proper frequencies to the tweeter and the mid-range. The crossover also provides the protection needed so that the speakers do not receive improper frequencies that will harm the speakers You can assume that any good quality speakers that you purchase will be crossed over correctly. Another Note on system design. It is critical that you use the best wire to match the type of items you buy. All amplifiers as well as speakers need to be fed with high quality wire. On basic systems you can use the factory wires that run to the speakers but make sure you use high quality RCA cables as well as high quality power and ground cables with the proper connectors. This is one area you never want to cut corners on. Don t let a salesman talk you out of going with good cables. We at Outrageous Audio would .