Đang chuẩn bị liên kết để tải về tài liệu:
Build A Remote-Controlled Robot part 14

Tham khảo tài liệu 'build a remote-controlled robot part 14', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | 98 Chapter Six FIGURE 6-15. Lights and horn in place. 12-VOLT POWER OUTLET Questor s 12-volt power outlet allows you to draw power directly from his batteries for use with other 12-volt devices e.g. radios and mini televisions. The outlet itself is a cigarette lighter mount available at most electronics stores. Since most radios and TVs come with auto lighter plugs this was the logical choice. Mount the outlet on the left side of Questor s lower framework. Figure 6-16 shows how to wire the outlet to the power grid on Questor s remote control board. BOW TIE Another light up option you can add to your robot is a bow tie with flashing LEDs light emitting diodes like that pictured in Fig. 6-17. The bow tie is available at most novelty shops or from the supplier listed in the back of this book. The bow tie Skin and Finishing Touches 99 FIGURE 6-16. 12-volt outlet wiring guide. FIGURE 6-17. Light-up bow tie. operates off a 9-volt battery taped to the inside of Questor s front body panel. The battery will last for a long time with intermittent use. Also the tie has no on off switch so you ll have to wire and mount one yourself. Figure 6-18 shows how to do this. The tie is held to the robot with a strip of double sided tape like that used to mount the body panels. 100 Chapter Six FIGURE 6-18. Bow tie wiring diagram. PAINTING AND TRIMMING THE BODY You can paint your version of Questor any way you wish but if you are making a duplicate model of my version the following photos Figs. 6-19 to 6-22 will better show how he is painted. I only painted the upper portion of the robot so the robot would look as if he were wearing a tuxedo jacket. The two colors used are black and white. To paint the arms it is best to remove them from the body the upper arm is covered with lengths of leftover black hosing from the vacuum system. Simply cut the hose to length and slide it over the upper arm the end-cap at the top will hold it in place. Make sure you also paint Questor s serving tray if