Đang chuẩn bị liên kết để tải về tài liệu:
HP-UX/Tru64 UNIX System Administration Interoperability phần 4

1. Đăng nhập như superuser (root). 2. Gọi Menu sysman. 3. Chọn Hỗ trợ và dịch vụ. 4. Chọn Tạo Ảnh chụp Dump. Dump Tạo Ảnh chụp cửa sổ sẽ mở ra.Thời gian chạy Dumps vụ tai nạn sụp đổ Dumps Vụ tai nạn Dumps lệnh và tiện ích | Network Administration Configuring Basic Network Services HP-UX 6. Select Actions- Modify. The Configure LAN Card dialog box opens. The following information is already provided Card Name Displays the logical name for the network interface. HP-UX chooses the name automatically by selecting the next available logical name based on the number of adapters of the same type currently in the system. Ip Interface This read-only field displays the IP logical interface number. You can assign multiple IP addresses to an interface card. Each IP address is an IP logical interface and is assigned an index number. The IP interface index number is appended to the physical card name to form the interface name. For example if the physical card lan0 has two IP interfaces the interface names are lan0 0 and lan0 1. If the interface number is not specified it defaults to 0. The interface name lan0 is equivalent to lan0 0. Hardware Path This is the hardware path for the interface card. This number provides information about the card slot. Station Address Is a unique 12-digit hexadecimal hardware address supplied with each network interface card. This address is automatically sensed by the system. 7. Choose the appropriate network protocol from the option menu for the Card Type. For interface cards that support both the Ethernet protocol and IEEE 802.3 select either Ethernet a de-facto standard link-level protocol or Sub-Network Access Protocol SNAP 802.3. HP-UX requires that IP packets transmitted over IEEE 802.3 use SNAP Sub-Network Access Protocol encapsulation. Chapter 7 109 Network Administration Configuring Basic Network Services HP-UX If you configure an interface card with an Ethernet IP logical interface and a SNAP802.3 IP logical interface the two logical interfaces must be on different IP subnets. 8. You may need to set the AutoSense option ON or OFF for the Token Ring Autosense function this option is used with the Ring Speed and Duplex Mode settings. If Autosense is ON then