Đang chuẩn bị liên kết để tải về tài liệu:
Configuring Frame-Relay Subinterfaces

Tham khảo tài liệu 'configuring frame-relay subinterfaces', công nghệ thông tin, hệ điều hành phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | Cisco Svstems I Lab 5.2.3 Configuring Frame-Relay Subinterfaces Router 3 rame Relay Cloud Router 2 Paris DTE class cisco Router 1 Berlin DTE class cisco Straight-through cable Serial cable Console rollover Crossover cable cisco 192.168.4.2 24 192.168.6.1 24 201 203 192.168.2.1 24 IGRP 100 192.168.5.2 24 192.1686.2 24 301 302 192.168.3.1 24 IGRP 100 Router 1 Amsterdam DTE class Router 1 PVC Router 2 1 1 PVC 192.168.4.1 24 192.168.5.1 24 102 103 192.168.1.1 24 IGRP 100 Enable Enable Secret VTY Password Console passwords Router Router Designation Name interface Serial 0 type Address DLC1 FastEthernet Routing number 0 Address Protocol Subnet Mask Objective Configure three routers in a full-mesh Frame Relay network. An Adtran Atlas550 Frame Relay emulator is used to simulate the switch Frame Relay cloud. Background Preparation Cable a network similar to the one in the diagram above. Any router that meets the interface requirements displayed on the above diagram may be used. This includes the following and any of their possible combinations 800 series routers 1600 series routers 1700 series routers 2500 series routers 2600 series routers Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series 1 - 7 CCNA 4 WAN Technologies v 3.0 - Lab 5.2.3 Copyright 2003 Cisco Systems Inc. routers. Any other router used may produce slightly different output. Conduct the following steps on each router unless specifically instructed otherwise. Start a HyperTerminal session as. Note Refer to the erase and reload instructions at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. Step 1 Configure the routers Configure the following according to the chart The hostname The console The virtual terminal The enable passwords The fastethernet interfaces according to the chart If there is a problem