Đang chuẩn bị liên kết để tải về tài liệu:
Lab 6.1.6 Configuring of Static Routes

Cable a network similar to the one in the previous diagram. Any router that meets the interface requirements may be used. Possible routers include 800, 1600, 1700, 2500 and 2600 routers, or a combination. Refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise | Lab 6.1.6 Configuring Static Routes Router 1 Router 2 Straight-through cable Rollover console cable Serial cable Crossover cable Router designation Router name Enable secret password Enable VTY and Console passwords Routing protocol RIP network statements Router 1 GAD class cisco none none Router 2 BHM class cisco none none Router designation IP host name FastEthernet 0 address Interface type Serial 0 Serial 0 address Interface type Serial 1 Serial 1 address Subnet mask all addresses Router 1 GAD 192.168.14.1 DCE 192.168.15.1 NA No address 255.255.255.0 Router 2 BHM 192.168.16.1 DTE 192.168.15.2 NA No address 255.255.255.0 Objective Configure static routes between routers to allow data transfer between routers without the use of dynamic routing protocols. Background Preparation Cable a network similar to the one in the previous diagram. Any router that meets the interface requirements may be used. Possible routers include 800 1600 1700 2500 and 2600 routers or a combination. Refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise. Start a HyperTerminal session as performed in the Establishing a HyperTerminal session lab. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. 1 - 6 CCNA 2 Routers and Routing Basics v 3.0 - Lab 6.1.6 Copyright 2003 Cisco Systems Inc. Step 1 Configure both routers a. Enter the global configuration mode and configure the hostname as shown in the chart. Then configure the console virtual terminal and enable passwords. If there are any difficulties refer to the Configuring router passwords lab. Configure interfaces and IP host .