Đang chuẩn bị liên kết để tải về tài liệu:
DSX-1 Digital Signal

Traditionally, as DSX frameworks grew, DSX chassis and the jumper rings associated with them were added one by one. Existing cross-connect jumpers had to be fed into the new jumper rings as the new chassis were installed. Jumper movement in any one direction was often restricted since jumper rings were not present at unequipped chassi positions. If jumpers were pulled too tightly across unequipped positions, feeding them into new rings was difficult if not impossible. Also, jumpers may have cut across corner as they transitioned from vertical to horizontal wireways | DSX-1 Digital Signal Cross-Connect Rack Framework and Accessories Seventh Edition . . . . . . F g r IIC Table of Contents Available Framework Types Network Unequal Flange See Page 12 Non-Network Unequal Flange See Page18 Channel Rack Overhead Supported See Page 24 Channel Rack Floor Supported See Page 25 Table of Contents SKELETON BAYS DESCRIPTION.1 DSX-1 SKELETON BAYS Rear Cross-Connect.2-3 Front Cross-Connect.4-5 DSX-3 SKELETON BAYS Rear Cross-Connect.6-8 Front Cross-Connect.9-11 NETWORK UNEQUAL FLANGE EARTHQUAKE RACKS Framework.12 Accessories.13-17 NON-NETWORK UNEQUAL FLANGE RACKS Rack Framework.18 Accessories.19-21 NETWORK AND NON-NETWORK RACK ACCESSORIES 7 Toll and 12 Universal End Guard Panels.22 Rack Installation Kits.23 CHANNEL RACKS Framework Overhead Supported .24 Framework Floor Supported .25 Accessories.26-30 .