Đang chuẩn bị liên kết để tải về tài liệu:
Nghệ thuật xếp hình Nhật Bản:triceratop

Nghệ thuật xếp hình: triceratop. Tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn. | Triceratops by Jerry Harris Begin with a square white side up with the vertical diagonal precreased. A square of 10 results in a model of approximately 5.8 long and 1.67 tall at the hip. Valley fold the left edge in half creasing only at the very edge and unfold. Valley fold 1 4 at the left side again creasing only at the edge and unfold. Valley fold 1 8 at the left side again creasing only at the edge and unfold. This is the mark that is referred to in Step 7. Valley fold lower angle bisectors to the center and unfold. Valley fold connecting the tops of the angle bisectors and unfold. Valley fold through a point 2 3 the way between the top point and the crease connecting the angle bisectors made in Step 5 and unfold. Valley fold the top point down so the 1 8 mark from Step 3 touches the 2 3 line from Step 6. Reverse fold the top corners in to the center creating a small preliminary base at the top. Remake the angle bisectors through the new flaps at the top and unfold. 11. 12. Valley fold the top point down connecting the tops of the angle bisectors. Mountain fold the loose corners at the sides under. Reverse fold the top corners in to the center creating another preliminary base at the top. Valley fold the lower left side of the preliminary base at the top in half. As you do this you will have to squash the flap underneath folding the inner edge of the colored flap to the outer edge. The result. The first small preliminary base should lay perfectly between the edges and the center forming 1 4 of the larger one made in Step 12 . Valley fold the angle bisector at the top using only the top flap and unfold the model will not lay flat as you do this . Turn over from side-to-side. Valley fold the corresponding angle bisector on the back. The paper will not lay flat as you do this and you ll have to crease the top part and bottom part separately. Unfold. Reverse fold the right side on the fold you just made. Again the paper will not lay flat. Turn back over from .