Đang chuẩn bị liên kết để tải về tài liệu:
Nghệ thuật xếp hình Nhật Bản:tyrannosaurus

Nghệ thuật xếp hình: tyrannosaurus. Tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn. | Tyrannosaurus Begin with a square white side up with both diagonals precreased. Valley fold the top edges to the center line creasing the angle bisectors. Pull out the point the one folded down in Step 2 hidden by the flaps folded down in Step 3. The next few diagrams are close-ups of the top of the model. Valley fold the top point to the intersection of the angle bisectors created in Step 1. Valley fold both sides of the new top edge and the attached paper below it to the center line. Squash fold the point at the top to create a small preliminary fold. 3 Squash fold the right side of the preliminary fold. Repeat Steps 6-8 in mirror image on the left side of the model. Fold the left flap of the petal back over to the right. Petal fold the flap leaving the petal pointing down. folds up to meet the top of the model. This point will be the lower jaw. The next step returns to a full view of the model. 11 12 Valley fold the sides of the small white triangle to its lower edge and unfold. Valley fold the lower right corner of the long rectangular flap from Step 3 up along the angle bisector. The next few steps are close-ups of this region. 13 Repeat Steps 12-13 on the left side of the model. Rabbit ear the white triangle. The point created by the rabbit ear will become the first toe see Step 65 . The next step returns to a full view of the model. Turn the model over from side-to-side. The next diagrams are enlarged. Create a new horizontal diagonal crease by valley folding the lower point to the upper then unfold. Valley fold the top edges to the new horizontal diagonal line and unfold creating new angle bisectors. Valley fold the top point down such that the crease goes through the intersection of the angle bisectors from Step 17 and unfold. Turn the model over from side-to-side. 19 20 21 Valley fold the top point down so that the crease connects the points where the angle bisectors from Step 16 intersect the top edges. The point falls on the intersection of the vertical