Đang chuẩn bị liên kết để tải về tài liệu:
Lecture Automatic control systems technology - Lesson 19: Process characteristics-1st order lag and dead-time processes

Đang chuẩn bị nút TẢI XUỐNG, xin hãy chờ

Lecture Automatic control systems technology - Lesson 19: Process characteristics-1st order lag and dead-time processes. After this presentation you will be able to: describe typical 1st order lag and dead-time process models found in control systems; write mathematical formulas for 1st order and dead-time process models; compute the parameters of process models; identify the Bode plots of typical process models; . Please refer to the content of document. |

TÀI LIỆU LIÊN QUAN

Lecture Automatic control systems technology - Lesson 1: Introduction to control systems technology

Lecture Automatic control systems technology - Lesson 2: Performance of control systems

Lecture Automatic control systems technology - Lesson 7: Thermal and mechanical element math models in control systems

Lecture Automatic control systems technology - Lesson 16: Basic control modes

Lecture Automatic control systems technology - Lesson 17: Combined mode control

Lecture Automatic control systems technology - Lesson 8: Modeling physical systems with linear differential equations

Lecture Automatic control systems technology - Lesson 9: Proportional control action

Lecture Automatic control systems technology - Lesson 3: Operational amplifier circuits in analog control

Lecture Automatic control systems technology - Lesson 5: Mathematical models of electrical control system components

Lecture Automatic control systems technology - Lesson 22: Determining control stability using bode plots