tailieunhanh - Nghiên cứu chế tạo Blend Cao su clopren/epoxy chịu mài mòn

Presently, in mineral industry of Vietnam 2 types of spiral separators are employed: (i) 1200 mm-diameter type made of unplastized PVC (type A) and (ii) 600 mm-diameter type made of polymer composite (PC) and surface layer is chloroprene rubber (type B). In practice it has proven that type B has conductivity considerably higher than type A and easy movement resulting from smaller size. | Tạp chí Hóa học T. 44 2 Tr. 223 - 227 2006 NGHIÊN cứu CHE TẠO BLEND CAO su CLOPREN EPOXy CHỊU MÀI MÒN Đến Tòa soạn 3-8-2005 HOÀNG NAM HÀ THU HƯỜNG Trung tâm nghiên cứu vật liệu polyme Trường Đại học Bách khoa Há Nội SUMMARY Presently in mineral industry of Vietnam 2 types of spiral separators are employed i 1200 mm-diameter type made of unplastized PVC type A and ii 600 mm-diameter type made of polymer composite PC and surface layer is chloroprene rubber type B . In practice it has proven that type B has conductivity considerably higher than type A and easy movement resulting from smaller size. However in order to manufacture the type B two following issues must be tackled simultanenously 1 Produce rubber better anti-abrasion than unplastized PVC and 2 This rubber has excellent adhesion to substrate on the basis of glassfibre-reinforced unsaturated polyesters. For tackling those issues research has been done to produce a blend on the basis of chloroprene rubber CR vulcanised by a compound of amine VS1 and epoxy resin EP . Selfvulcanisability of blend CR EP VS1 the effect of vulcanisation time on tensile strength and tear strength of blend adhesion to PC substrate abrasion and ozone resistance were investigated. With the composition of CR EP VS1 50 50 wt the blend achieved tensile strength of MPa tear strength of N mm shear strength of KG cm and good ozone resistance. When blend was sustained at 40oC for 2 hours the resulting blend obtained the lowest value of abrasion g in comparison with g of unplastized PVC 33 increase . I - MỞ ĐẦU II - THỰC NGHIỆM Hiện nay trong công nghiệp tuyển khoáng của nước ta sử dụng hai loại vít tuyển loại chế tạo từ nhựa PVC cứng có đường kính 1200 mm và loại chế tạo từ nhựa polyeste không no gia cường bằng sợi thuỷ tinh có phủ một lớp phủ cao su chịu mài mòn do úc lắp đặt trước đây để tuyển quặng titan ở Hà Tĩnh. Loại vít của úc có kích thước gọn đường kính 600 mm hiệu quả tuyển cao nhưng vấn đề khó nhất ở đây

TÀI LIỆU MỚI ĐĂNG
crossorigin="anonymous">
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.