tailieunhanh - Intuitive Programming System Walk-Through For Lathes

These instructions are an in-depth look at each of the Intuitive Programming System (IPS) menus. A more formal description is given for each of the entries to help better define the on-screen help for new users. These instructions are to be used with the Lathe Operator’s Manual (96-8700) and Toolroom Lathe Operator’s Addendum (96-0112) The menus are navigated by using the left and right arrow keys. | Intuitive Programming System Walk-Through For Lathes 1 ES0609 rev D 4 09 Introduction These instructions are an in-depth look at each of the Intuitive Programming System IPS menus. A more formal description is given for each of the entries to help better define the on-screen help for new users. These instructions are to be used with the Lathe Operator s Manual 96-8700 and Toolroom Lathe Operator s Addendum 96-0112 The menus are navigated by using the left and right arrow keys. To select a menu item press Write Enter. Some menus have sub-menus in which case use the left and right arrow keys and press Write Enter to select a sub-menu. Use the arrow keys to navigate through the variables enter values by using the number pad and then press Write Enter. To exit or go back to another selection press Cancel. Pressing any of the buttons under the Display heading will exit the IPS menus as will any of the mode keys . Edit Mem MDI etc. . To return to the IPS menu press Handle Jog. A representation of the machine keypad is included at the end of this document for reference. This guide will help the user develop full CNC programs by means of the IPS screen. Note that a program entered through the Toolroom Lathe screens is also accessible by going to full CNC MDI mode. The program can be edited and saved from the full CNC mode. NOTE The IPS menu is displayed at power up and is available in the following configurations 10 LCD and software version and earlier - IPS 15 LCD and software version and earlier - IPS upgradable to Profile Creator 15 LCD and software version and later - IPS with Profile Creator Manual Mode Power on the machine and press RESET until all alarms have cleared. Press POWER ON RESTART to zero the machine. The IPS menu can now be accessed by pressing MDI DNC then pressing PRGRM CONVRS. Press WRITE ENTER to display the IPS menu MAnUAl tab. manealFup AmferN faceMfer radius ll tapẸadingEad re-cutQving X AND Z AXES the AXES CAN BE electronically