tailieunhanh - Learning AutoCAD 2010, Volume 2 phần 9

Tạo mẫu hatch và gradient điền trên các đối tượng trong bản vẽ. Chỉnh sửa nở và gradient điền đã được đặt trong bản vẽ. Làm việc với nội dung thể sử dụng lại Khi bạn tạo một tập tin bản vẽ, bạn đang tạo và | 5. Move the cursor straight up and click at the intersection. 6. Click at the center of the first ellipse. 7. To trim part of the second ellipse Start the Trim command. Click the first ellipse as the cutting edge. Click the far left side of the second ellipse as the object to trim. The left ellipse is trimmed to an elliptical arc as shown. 8. To create an ellipse in the top view to represent the outer edge of the inclined surface On the Home tab click Draw panel Ellipse. Right-click. Click Arc. Right-click. Click Center. 9. Click the center of the first ellipse. 10. To define the endpoint of the first axis snap to the end of the horizontal line. 11. To define the endpoint of the second axis snap to the intersection on the right. 12. To specify the start angle snap to the end of the horizontal line. 13. To specify the end angle position snap to the end of the horizontal line on the top. 14. Freeze layer construction. Zoom to display your completed drawing. 15. Close all files. Do not save. Lesson Creating Ellipses 289 Lesson Using Tables This lesson describes how to create and modify table styles and how to create tables using the Tablestyle and Table commands. You can use tables in your drawings to meet a number of needs. For example you might use them to show revisions in the drawing or to create tabulated dimensions as shown. The following illustration represents a tabular dimension table. PART NAME A B c B762 762 606 305 BS3S co fn co 762 Í2 B914 914 838 381 8991 991 915 419 B10Ê7 1067 991 457 Objectives After completing this lesson you will be able to Describe tables. Use the Tablestyle command to create table styles. Create tables and enter values in the table cells. 290 Chapter 11 Creating Additional Drawing Objects About Tables You can use tables to organize data into columns and rows. Data can be entered in the table or extracted from objects including blocks that contain special attributes. When you place information into tables you can format rows and .