tailieunhanh - SIEMENS - simatic modifying the system during operation via CiR

This manual gives you a complete overview about modifications to plants during an operation via CiR. It conveys the required background knowledge as well as the operating procedure in HW Config. It is intended for persons working in the configuration, commissioning and automation system service field. | SIEMENS Preface Contents Requirements and Overview SIMATIC Modifying the System during Operation via CiR Manual CiR Objects and CiR Modules User Interface Reconfiguration of Existing Modules in ET 200M Stations Notes on Reconfiguration in RUN Mode Depending on the I O How a Reconfiguration in RUN Mode Affects the Process Appendices Compatibility Index 1 2 3 4 5 6 A Edition 01 2004 A5E00266885-01 Safety Guidelines This manual contains notices intended to ensure personal safety as well as to protect the products and connected equipment against damage. These notices are highlighted by the symbols shown below and graded according to severity by the following texts Danger indicates that death severe personal injury or substantial property damage will result if proper precautions are not taken. Warning indicates that death severe personal injury or substantial property damage can result if proper precautions are not taken. Caution indicates that minor personal injury can result if proper precautions are not taken. Caution indicates that property damage can result if proper precautions are not taken. Notice draws your attention to particularly important information on the product handling the product or to a particular part of the documentation. Qualified Personnel Only qualified personnel should be allowed to install and work on this equipment. Qualified persons are defined as persons who are authorized to commission to ground and to tag circuits equipment and systems in accordance with established safety practices and standards. Correct Usage Note the following Warning This device and its components may only be used for the applications described in the catalog or the technical description and only in connection with devices or components from other manufacturers which have been approved or recommended by Siemens. This product can only function correctly and safely if it is transported stored set up and installed correctly and operated and maintained as recommended. .