tailieunhanh - Code of Standard Practice for Steel Buildings and Bridges Part 10

Tham khảo tài liệu 'code of standard practice for steel buildings and bridges part 10', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | 68 ments in Sections through shall be met. . The Fabricator and the Erector shall provide the Inspector with access to all places where the work is being performed. A minimum of 24 hours notification shall be given prior to the commencement of work. . Inspection of shop work by the Inspector shall be performed in the Fabricator s shop to the fullest extent possible. Such inspections shall be timely in-sequence and performed in such a manner as will not disrupt fabrication operations and will permit the repair of nonconforming work prior to any required painting while the material is still in-process in the fabrication shop. . Inspection of field work shall be promptly completed without delaying the progress or correction of the work. . Rejection of material or workmanship that is not in conformance with the Contract Documents shall be permitted at any time during the progress of the work. However this provision shall not relieve the Owner or the Inspector of the obligation for timely in-sequence inspections. . The Fabricator and the Erector shall be informed of deficiencies that are noted by the Inspector promptly after the inspection. Copies of all reports prepared by the Inspector shall be promptly given to the Fabricator and the Erector. The necessary corrective work shall be performed in a timely manner. . The Inspector shall not suggest direct or approve the Fabricator or Erector to deviate from the Contract Documents or the approved Shop and Erection Drawings or approve such deviation without the written approval of the Owner s Designated Representatives for Design and Construction. Code of Standard Practice for Steel Buildings and Bridges March 7 2000 AMERICAN INSTITUTE OF STEEL CONSTRUCTION 69 SECTION 9. CONTRACTS . Types of Contracts . For contracts that stipulate a lump sum price the work that is required to be performed by the Fabricator and the Erector shall be completely defined in the Contract .