tailieunhanh - Code of Standard Practice for Steel Buildings and Bridges Part 5

Tham khảo tài liệu 'code of standard practice for steel buildings and bridges part 5', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | 23 choose to make CAD files or copies of the Design Drawings available to the Fabricator and may charge a service or licensing fee for this convenience. In doing so a carefully negotiated agreement should be established to set out the specific responsibilities of both parties in view of the liabilities involved for both parties. For a sample contract see CASE Document 11. The CAD files and or copies of the Design Drawings are provided to the Fabricator for convenience only. The information therein should be adapted for use only in reference to the placement of Structural Steel members during erection. The Fabricator should treat this information as if it were fully produced by the Fabricator and undertake the same level of checking and quality assurance. When amendments or revisions are made to the Contract Documents the Fabricator must update this reference material. When CAD files or copies of the Design Drawings are provided to the Fabricator they often contain other information such as architectural backgrounds or references to other Contract Documents. This additional material should be removed when producing Shop and Erection Drawings to avoid the potential for confusion. . Approval Except as provided in Section the Shop and Erection Drawings shall be submitted to the Owner s Designated Representatives for Design and Construction for review and approval. These drawings shall be returned to the Fabricator within 14 calendar days. Approved Shop and Erection Drawings shall be individually annotated by the Owner s Designated Representatives for Design and Construction as either approved or approved subject to corrections noted. When so required the Fabricator shall subsequently make the corrections noted and furnish corrected Shop and Erection Drawings to the Owner s Designated Representatives for Design and Construction. Commentary As used in this Code the 14-day allotment for the return of Shop and Erection Drawings is intended to represent the .