tailieunhanh - Meshing User's Guide ANSYS phần 2

nói m × n n × n. • Một mảng đa chiều, nói m × . × n. Mảng phải luôn luôn được chiều giác và tất cả các yếu tố phải có cùng một kiểu dữ liệu. Nói cách khác, 2 x 3 ma trận phải có 3 yếu tố (ví dụ, số) trên mỗi 2 hàng. Bảng đưa ra ví dụ về làm thế nào để truy cập các yếu tố của mảng. | Usage in Workbench INTERIOR MASS_FLOW_INLET OUTFLOW OUTLET_VENT PERIODIC POROUS_JUMP PRESSURE_FAR_FIELD PRESSURE_INLET PRESSURE_OUTLET RADIATOR RECIRCULATION_INLET RECIRCULATION_OUTLET SOLID SYMMETRY THIN VELOCITY_INLET WALL Note For details about the boundary face zone and continuum cell zone types in ANSYS FLUENT refer to the documentation available under the Help menu within ANSYS FLUENT. Zone Type Assignment This section describes zone naming and the zone type assignment process. Zone Naming By default zones are named after the part and body from which they are derived. For example part part and body solid body will result in a zone name of part-solid_body. When the zone name is created Any invalid characters such as the space in solid body are replaced by an underscore character solid_body . Names that begin with a digit are prefixed by zone. If the part name and the body name are identical only the body name is used to create the zone name. The same rule applies to single body parts. If a zone was created for a Named Selection as described in Classes of Zone Types in ANSYS FLUENT p. 25 the name of the zone is set to the name of the Named Selection. In cases where the zone naming process could lead to conflicting zone names for example in a situation where the potential exists for a zone name that is already in use to be used to name a new zone one of the following approaches is used If the zone type is not similar to the zone name in question the zone type will be prefixed to the zone name to make it unique. For example an existing continuum zone named fluid and a new boundary zone named fluid with zone type WALL will result in the boundary zone being renamed wall-fluid. If the zone type is similar to the zone name in question a unique integer will be suffixed to the zone name preceded by an underscore character _ . For example an existing continuum zone named fluid and a second continuum zone named fluid with zone type FLUID will result in the second .