tailieunhanh - CNA 2: Routers and Routing Basics V3.1.1 Instructor Lab Manual

Tham khảo sách 'cna 2: routers and routing basics instructor lab manual', công nghệ thông tin, chứng chỉ quốc tế phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | Cisco Systems CCNA 2 Routers and Routing Basics Instructor Lab Manual This document is exclusive property of Cisco Systems Inc. Permission is granted to print and copy this document for non-commercial distribution and exclusive use by instructors in the CCNA 2 Routers and Routing Basics course as part of an official Cisco Networking Academy Program. Cisco SrsTEMS Lab Connecting Console Interfaces - Instructor Version 2500 straight-through cable Serial cable Console Rollover Crossover cable Objective Connect a PC to a router using a console or rollover cable. Background Preparation A console cable is necessary to establish a console session in order to allow checking or changing the configuration of the router. The following resources will be required Workstation with a serial interface Cisco Router Console or rollover cable for connecting the workstation to the router 1 - 833 CCNA 2 Routers and Routing Basics v - Lab Copyright 2003 Cisco Systems Inc. Step 1 Identify connectors and components a. Examine the router and locate the RJ-45 connector labeled Console. Step 2 Identify the computer serial interface COM 1 or 2 a. Examine the computer and locate a 9-pin or 25-pin male connector labeled serial. It may or may not be identified. J pin male Step 3 Locate the adapter for the console cable a. Locate the RJ-45 to DB-9 or RJ-45 to DB-25 adapter depending on the available PC serial port. An RJ-45 to DB-9 adapter is shown below. 2 - 833 CCNA 2 Routers and Routing Basics v - Lab Copyright 2003 Cisco Systems .