tailieunhanh - Advances in Lasers and Electro Optics Part 5

Tham khảo tài liệu 'advances in lasers and electro optics part 5', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | Artificial Intelligence Tool and Electronic Systems Used to Develop Optical Applications 187 case is determined by the control of the XY displacements. In absence of the servo motors implementation manual control can be also carried out keeping the reliability of the measurements due to the worm drives coupled to the XY table. Similar structures can be realized on the base of the meter presented here for example using recycled printer rails or making mechanical structures of low cost. The bigger inversion would be realized on the detection circuit which involves the DSPIC programming. A total scanning area at least at 20x20 cm2 is suitable in order to realize measurements of the luminaries of larger sizes. Also it is suggested to be very careful in the selection of all parts of the prototype because as we mentioned the little variations for example in the gear teeth can produce deviations in the generated profiles. The implementation of the rectangular meter permits to observe with a great detail the profile produced as a result of the beamwidth of the illumination source under test. The generated information permits us to realize a comparison with other spherical prototype developed by our research group and to have complete information about the total irradiance profile. The rectangular prototype provides empirical information necessary not only for manufacturers but also for research activities. We found this prototype very useful due to the controllability of position which increases the feasibility of the measurements and provides a very complete irradiance pattern for the case of directive illumination sources. The application of the XY table automation shows the high potential of this type of devices. 3. An artificial intelligence development tool to micro engraved with laser MGL to control and optimization of the laser engrave process The purpose of this project is to make devices that can be used in the optical fiber sensors which requires micrometric .