tailieunhanh - Designation: C 595 – 00ae1 - Standard Specification for Blended Hydraulic Cements1

This standard is issued under the fixed designation C 595; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. | Designation C 595 00ae1 Standard Specification for Blended Hydraulic Cements1 This standard is issued under the fixed 46 1130011 c 595 the number immediately following the designation indicates the year of original adoption or in the case of revision the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon e indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. e1 Note was edilorially corrected December 2000. 1. Scope This specification pertains to ff cclasscroOblcndcd hydraulic cements for both general and special applications using slag or pozzolan or both with portland cement or portland cement clinker or slag with lime. Note 1 This specification prescribes ingredients and proportions with some performance requirements whereas Performance Specification C 1157 is a blended cement specification in which crf ciũìì iũu alone govern the products and their acceptance. For properties where values are given in both SI and non SI units the values in SI units are to be regarded as the standard. Values in SI units shall be obtained by measurement in SI units or by appropriate conversion using the Rules for Conversion and Rounding given in Standard IEEE ASTM SI 10 of measurements made in other units. The text of this standard refers to notes and footnotes which provide explanatory material. These notes and footnotes excluding those in tables and gures are not requirements of the standard. 2. Referenced Documents ASTM Standards C 109 C 109M Test Method for Compressive Strength of Hydraulic Cement Mortars Using 2-in. or 50-mm Cube Specimens 2 C 114 Test Methods for Chemical Analysis of Hydraulic Cement2 C 150 Specif cation For Portland Cement2 C 151 Test Method for Autoclave Expansion of Portland Cement2 C 157 Test Method for Length Change of Hardened Hydraulic-Cement Mortar and Concrete3 C 183