tailieunhanh - Motherboard Installation

Upon completion of this lab, the motherboard will be placed into the case and secured. The CPU, the heat sink, the LEDs, and the memory will also be installed. | Lab Motherboard Installation Estimated time 45 Minutes Objective Upon completion of this lab the motherboard will be placed into the case and secured. The CPU the heat sink the LEDs and the memory will also be installed. Equipment The following equipment is required for this exercise ESD wrist strap and antistatic mat Tool kit and screws Motherboard manual CPU with fan and heat sink Thermal grease RAM use the appropriate type for the motherboard Scenario The case for a friend s computer should be ready for the next step. Continue to work on installing the CPU and RAM. Procedures Be sure to wear an anti-static wrist strap for this lab and use extreme care. One discharge of static electricity could render a motherboard useless. In this lab continue to work on the PC that is being built and properly install the motherboard CPU heat sink CPU fan and RAM. Step 1 Lay the motherboard down on the antistatic mat. Identify the CPU socket on the motherboard. The CPU socket is keyed so that the CPU may only be inserted one way. What CPU type does the motherboard support Step 2 Pick up the CPU and locate pin one. Note that the CPU may only be inserted one way into the CPU socket. Install the CPU into the CPU socket. If the CPU is being installed into a Zero Insertion Force ZIF socket no force is necessary. If any force has to be applied the CPU is not lined up correctly. After the CPU is seated adjust the CPU socket lever until it is in the locked position. When the lever is locked the CPU is secure. 1 - 3 IT Essentials I - Lab Copyright 2002 Cisco Systems Inc. Who is the manufacturer of the CPU __ Step 3 Attach the cooling fan to the heat sink. Use the four screws that came with the cooling fan to attach the fan securely to the top of the heat sink. Note Some heat sinks are already equipped with a fan and will not need to be secured with screws. Is the heat sink being installed attached with screws Step 4 To attach the .