tailieunhanh - Configuring an IP Address and Default Gateway in Windows 2000

The Air Guitar Company has just installed a server running Windows 2000. The company has asked the network administrator to configure the system with an IP address and subnet mask. | Lab Configuring an IP Address and Default Gateway in Windows 2000 Estimated Time 20 Minutes Objective Configure a Windows 2000 Professional IP address. Equipment The following equipment is required for this exercise A computer system running Windows 2000 Professional Network connection from the system to hub switch or some other host Scenario The Air Guitar Company has just installed a server running Windows 2000. The company has asked the network administrator to configure the system with an IP address and subnet mask. Procedures Before beginning this lab make sure the Windows 2000 system is ready for you to log in. Power the server on if necessary. Ask the instructor or a lab technician for the appropriate IP address information for the system being worked on. Record that information in the table provided Host IP Address Configuration IP address Subnet mask Default gateway DNS server DHCP server Enabled Disabled Note If the instructor provides a DHCP server write down the IP range subnet mask and default gateway for the network. 1 - 3 IT Essentials II - Lab Copyright 2002 Cisco Systems Inc. Step 1 Log in Log in as Administrator. On a typical system only the administrator can configure an IP address. Step 2 Configure TCP IP to use a static IP address Right-click My Network Places and then click Properties. This will display the Network and Dial-Up Connections window. 1. Right-click Local Area Connection and then select Properties. 2. The Local Area Connection properties dialog box appears. 3. Click TCP IP and then verify that the check box to the left of the entry is selected and then click Properties. 4. The Internet Protocol TCP IP Properties dialog box appears. 5. Click Use The Following IP Address. 6. In the IP Address box the Subnet Mask box and the Default Gateway box type the values that were entered in the table in the Procedures step of this lab. 7. Click OK. 8. Click OK to close the Local Area Connection Properties dialog box. 9. .