tailieunhanh - Lab 9.3.5 Troubleshooting Routing Issues with show ip route and show ip protocols
Cable a network similar to the one in the diagram. Any router that meets the interface requirements displayed on the above diagram, such as 800, 1600, 1700, 2500, 2600 routers, or a combination, may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce a slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise | Cisco SrsTEMS Lab Troubleshooting Routing Issues with show ip route and show ip protocols Objective Use the show ip route and show ip protocol commands to diagnose a routing configuration problem. Background Preparation Cable a network similar to the one in the diagram. Any router that meets the interface requirements displayed on the above diagram such as 800 1600 1700 2500 2600 routers or a combination may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce a slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise. Start a HyperTerminal session as performed in the Establishing a HyperTerminal session lab. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. 1 - 6 CCNA 2 Routers and Routing Basics v - Lab Copyright 2003 Cisco Systems Inc. Step 1 Configure the hostname passwords and interfaces on the Gadsden router a. On the Gadsden router enter the global configuration mode and configure the hostname as shown in the chart. Then configure the console virtual terminal and enable passwords. If there is a problem doing this refer to the Configuring Router Passwords lab. Configure interfaces as shown in the table. Step 2 Configure the routing protocol on the Gadsden router a. Go to the proper command mode and enter the following GAD config router rip GAD config-router network GAD config-router network GAD config-router exit GAD config exit Step 3 Save the Gadsden router configuration GAD copy running-config startup-config Destination filename startup-config Enter Step 4 Configure the hostname and passwords on the Birmingham router a. On the Birmingham .
đang nạp các trang xem trước