tailieunhanh - Lab 9.3.4 Troubleshooting using Traceroute

Use the traceroute Cisco IOS command from source router to destination router. Use the tracert MS-DOS command from source workstation to destination router. Verify that the networklayer between source, destination and each router along the way is working properly. Retrieve information to evaluate the end-to-end path reliability. Cable the network in the diagram. Any router that meets the interface requirements displayed on the above diagram such as 800, 1600, 1700, 2500, 2600 routers, or a combination, may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The. | Cisco SrsTEMS Lab Troubleshooting using Traceroute Router 1 Router 3 Straight-through cable Serial cable Console Rollover Crossover cable Router Designation Router Name Enable secret password Enable VTY and console password Routing protocol RIP network statements Router 1 GAD class cisco RIP 14 0 Router 2 BHM class cisco RIP Router 3 PHX class cisco RIP Router Designation Fast Ethernet 0 Address Interface type Serial 0 Serial 0 Address Interface type Serial 1 Serial 1 Address Subnet mask ail addresses IP host table entries Router 1 DCE NA No address BUM PHX Router 2 DTE DCE GAD PHX Router 3 NA No address DTE GAD BHM 1 - 3 CCNA 2 Routers and Routing Basics v - Lab Copyright 2003 Cisco Systems Inc. Objective Use the traceroute Cisco IOS command from source router to destination router. Use the tracert MS-DOS command from source workstation to destination router. Verify that the networklayer between source destination and each router along the way is working properly. Retrieve information to evaluate the end-to-end path reliability. Cable the network in the diagram. Any router that meets the interface requirements displayed on the above diagram such as 800 1600 1700 2500 2600 routers or a combination may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise. Start a HyperTerminal session as performed in the Establishing a HyperTerminal session lab. Erase and reload all routers in this lab assignment .