tailieunhanh - Lab 9.2.6 Troubleshooting Using Ping and Telnet

Tham khảo tài liệu 'lab troubleshooting using ping and telnet', công nghệ thông tin, quản trị mạng phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | Lab Troubleshooting Using Ping and Telnet Router designation Router name Enable secret password Enable VTY and Console passwords Routing protocol RIP network statements Router 1 GAD class cisco RIP Router 2 BHM class cisco RIP Router designation IP host name FastEthernet 0 address Interface type Serial 0 Serial 0 address Interface type Serial 1 Serial 1 address Subnet mask all addresses Router 1 BHM DCE DCE Router 2 GAD DTE DTE Objective Gather information about routing updates and routing protocols. Background Preparation Cable a network similar to the one in the diagram. Any router that meets the interface requirements displayed on the above diagram such as 800 1600 1700 2500 and 2600 routers or a combination may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce a slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise. Start a HyperTerminal session as performed in the Establishing a HyperTerminal session lab. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. 1 - 5 CCNA 2 Routers and Routing Basics v - Lab Copyright 2003 Cisco Systems Inc. Step 1 Configure the routers a. On the routers enter the global configuration mode and configure the hostname as shown in the chart. Then configure the console virtual terminal and enable passwords. If there are problems doing this refer to the Configuring Router Passwords lab. Next configure the interfaces and routing according to the chart. If there are problems doing this .