tailieunhanh - Lab 9.2.5 VTP Client and Server Configurations

When managing a switch, the Management Domain is always VLAN 1. The Network Administrator's workstation must have access to a port in the VLAN 1 Management Domain. All ports are assigned to VLAN 1 by default. Cable a network similar to the one of in diagram. The configuration output used in this lab is produced from a 2950 series switch. Any other switch used may produce different output. The following steps are to be executed on each switch unless specifically instructed otherwise. | Cisco SrsTEMS Lab VTP Client and Server Configurations Switch Designation Switch Name Enable Enable VTY VLAN 1 IP Subnet Secret and Console Address Mask Password Passwords VLAN Names Switch Port and Numbers Assignments Switch 1 Switch A class cisco VLAN 1 Native VLAN 10 Accounting VLAN 20 Marketing VLAN 30 Engineering faO 2 - 0 3 faO 4 - 0 6 faO 7 - 0 9 fa0 10-0 12 Switch 2 Switch B class cisco VLAN 1 Native VLAN 10 Accounting VLAN 20 Marketing VLAN 30 Engineering faO 2 - 0 3 faO 4 - 0 6 faO 7 - 0 9 faO 1O - 0 12 Straight-through cable ------------ Serial cable 7 Console Rollover .Crossover cable - Objective Create a basic switch configuration and verify it. Create multiple VLANs name them and assign multiple member ports to them. Configure the VTP protocol to establish Server and client switches. Create an trunk line between the two switches to allow communication between paired VLANs. Then test the VLANs functionality by moving a workstation from one VLAN to another. Background Preparation When managing a switch the Management Domain is always VLAN 1. The Network Administrator s workstation must have access to a port in the VLAN 1 Management Domain. All ports are assigned to VLAN 1 by default. Cable a network similar to the one of in diagram. The configuration output used in this lab is produced from a 2950 series switch. Any other switch used may produce different output. The following steps are to be executed on each switch unless specifically instructed otherwise. Start a HyperTerminal session. 1 - 8 CCNA 3 Switching Basics and Intermediate Routing v - Lab Copyright 2003 Cisco Systems Inc. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all switches in this lab assignment before continuing. Step 1 Configure the switch Configure the hostname access and command mode passwords as well as the management LAN settings. These values are shown in the

TỪ KHÓA LIÊN QUAN
crossorigin="anonymous">
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.