tailieunhanh - Lab 6.2.6 Add, Move,Change MAC Addresses

Cable a network similar to the one in the diagram. The configuration output used in this lab is produced from a 2950 series switch. Any other switch used may produce different output. The following steps are to be executed on each switch unless specifically instructed otherwise. Instructions are also provided for the 1900 Series switch, which initially displays a User Interface Menu. Select the “Command Line” option from the menu to perform the steps for this lab. Start a HyperTerminal session. Note: Go to the erase and reload instructions at the end of this lab. Perform those steps on all switches in this lab assignment before continuing | Cisco SrsTEMS Lab Add Move and Change MAC Addresses Switch Designation Switch Name Enable Secret Password Enable VTY and Console Passwords VLAN 1 IP Address Default Gateway IP Address Subnet Mask Switch 1 I AL Switch class cisco I Straight-through cable Serial cable Console Rollover Crossover cable Objective Create and verify a basic switch configuration. Move a PC from one switch port to another and add a new PC to the switch. Background Preparation Cable a network similar to the one in the diagram. The configuration output used in this lab is produced from a 2950 series switch. Any other switch used may produce different output. The following steps are to be executed on each switch unless specifically instructed otherwise. Instructions are also provided for the 1900 Series switch which initially displays a User Interface Menu. Select the Command Line option from the menu to perform the steps for this lab. Start a HyperTerminal session. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all switches in this lab assignment before continuing. Step 1 Configure the switch Configure the hostname access and command mode passwords as well as the management VLAN settings. These values are shown in the chart. If problems occur while performing this configuration refer to the Basic Switch Configuration lab. Step 2 Configure the hosts attached to the switch Configure the hosts to use the same IP subnet for the address mask and default gateway as on the switch. 1 - 8 CCNA 3 Switching Basics and Intermediate Routing v - Lab Copyright 2003 Cisco Systems Inc. There is a third host needed for this lab. It needs to be configured with the address . The subnet mask is and the default gateway is . Do not connect this PC to the switch yet. Step 3 Verify connectivity a. To verify that the hosts and switch are correctly configured ping the switch IP address