tailieunhanh - Lab 6.2.1 Verifying Default Switch Configuration

Cable a network similar to the one in the diagram. The configuration output used in this lab is produced from a 2950 series switch. Any other switch used in this lab may produce different output. The following steps are to be executed on each switch, unless specifically instructed otherwise. Start a HyperTerminal session. Note: Go to the erase and reload instructions at the end of this lab. Perform those steps on all switches in this lab assignment before continuing. | Cisco Svstems I Lab Verifying Default Switch Configuration Objective Investigate the default configuration of a 2900 series switch. Background Preparation Cable a network similar to the one in the diagram. The configuration output used in this lab is produced from a 2950 series switch. Any other switch used in this lab may produce different output. The following steps are to be executed on each switch unless specifically instructed otherwise. Start a HyperTerminal session. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all switches in this lab assignment before continuing. General Configuration Tips Using the question mark and arrow keys help to enter commands. Each command mode restricts the set of available commands. If there is difficulty entering a command check the prompt and then enter the question mark for a list of available commands. The problem might be a wrong command mode or using the wrong syntax. To disable a feature enter the keyword no before the command for example no ip address 1 - 6 CCNA 3 Switching Basics and Intermediate Routing v - Lab Copyright 2003 Cisco Systems Inc. Save the configuration changes to NVRAM so that the changes are not lost if there is a system reload or power outage. Switch Command Modes Command Mode Access Method Switch Prompt Displayed Exit Method User EXEC Log in. Switch Use the logout command. Privileged EXEC From user EXEC mode enter the enable command. Switch To exit to user EXEC mode use the disable exit or logout command. Global configuration From the privileged EXEC mode enter the configure terminal command. Switch config To exit to privileged EXEC mode use the exit or end command or press Ctrl-z. Interface configuration From the global configuration mode enter the interface type number command such as interface serial 0. Switch config-if To exit to global configuration mode use the exit command. Step 1 Enter privileged mode a. Privileged mode gives access