tailieunhanh - Exchange SQL And IIS- P131

Exchange SQL And IIS- P131:The following legacy Exchange features have been de-emphasized in Exchange Server 2007. What does that mean? It means that these features are still included in the Exchange product, but they’re not prioritized anymore, and will most likely disappear in the next Exchange release after Exchange Server 2007 | Transitioning from Exchange 2000 or 2003 to Exchange 2007 Chapter 10 627 Figure Switch the Exchange Organization to Native Mode 2 You will now receive a warning message similar to the one shown in Figure . Click Yes click OK and then close the Exchange 2003 System Manager. Figure Switch the Exchange Organization to Native Mode 628 Chapter 10 Transitioning from Exchange 2000 or 2003 to Exchange 2007 Some Independent Advice If it s not already the case we also recommend that you check Display routing groups and Display administrative groups refer back to Figure because we ll need to verify the existence of the routing and administrative groups created by Exchange 2007 Setup later in this chapter. If you re unsure whether your environment is ready for the deployment of the first Exchange 2007 server it s a good idea to run the latest version of the Exchange Best Practices Analyzer ExBPA to see if there s anything you need to do before you can proceed. The latest version of ExBPA version which you can download at includes an Exchange 2007 Readiness Check option as shown in Figure . Figure Exchange 2007 Readiness Check Option in ExBPA Transitioning from Exchange 2000 or 2003 to Exchange 2007 Chapter 10 629 Suppressing Link State Updates Depending on your topology Link State updates must be suppressed on any Exchange 2000 or 2003 servers in the Exchange legacy organization when you re deploying an Exchange 2007 Server. Bear in mind however that this is required only if you re planning to establish more than one routing group connector in the organization. To suppress Link State updates on any Exchange 2000 or 2003 servers in your organization 1. Log onto the respective servers then open the registry editor by clicking Start Run and typing regedit followed by pressing Enter. 2. Now navigate to HKEY_LOCAL_MACHINE System CurrentControlSet Services RESvc Parameters and right-click on Parameters then select New DWORD. Type .