tailieunhanh - Tài iệu Photoshop cs5 by Dayley part 80

Sử dụng Path Trong các phần trước, chúng tôi thảo luận về thành phần đường dẫn, các công cụ vector dùng để tạo ra những con đường, và bảng điều khiển đường dẫn được sử dụng để quản lý các đường dẫn. Trong phần này, chúng tôi đưa những kiến thức để sử dụng trong một số nhiệm vụ phổ biến mà bạn có thể thực hiện khi làm việc với nhiệm vụ. Những phần sau sẽ đưa bạn qua một số ví dụ của việc tạo ra và sử dụng các đường dẫn | Chapter 17 Working with Paths and Vector Shapes Tip You share paths between documents by selecting them in the Paths panel of one document and then dragging and dropping them into another document window in Photoshop. Using Paths In the previous sections we discussed path components the vector tools used to create paths and Paths panel used to manage paths. In this section we put that knowledge to use in some of the common tasks that you can perform when working with tasks. The following sections take you through some examples of creating and using paths. Creating a path The first example we look at is creating a basic path using the following steps 1. Select the Pen tool. 2. Set the mode to Paths in the Pen tool options menu. 3. Select the Ellipse tool from the Pen tool options menu. 4. Draw two circles by holding down the Shift key as shown in Figure . FIGURE Selecting the Ellipse tool from the Pen tool options menu with the mode set to Paths adds circles to the current path. 5. Use the Path Selection tool to select both circles and then click the Exclude overlapping shape area option in the Path Selection tool options menu to remove the center of the inner circle from the path area. 6. Click Combine in the Path Selection tool options menu to combine the path as shown in Figure . 565 Part V Painting Paths Shapes and Text FIGURE Using the Exclude overlapping shape area option on the two paths removes the inner area from the path shape area. 7. Use the Pen tool to add the points shown in Figure . FIGURE Using the Pen tool you can create a simple handle by adding four path points. 8. Use the Path Selection tool to move the new path so it touches the existing circles. 9. Use Convert Point tool to adjust the corners for the handle so they are round by dragging the direction points as shown in Figure . Click each corner to convert the corner to a smooth anchor and then drag away from the corner to add and shape the curves. FIGURE .