tailieunhanh - Hướng dẫn cách gấp giấy - 2

Tài liệu hướng dẫn bạn cách gấp giấy về tàu chiến đấu (Tài liệu bằng tiếng Anh) | Wayne Ko s Chi-Wing Fighter 10 spuare or larger is recommended Colour side up. Start with a waterbomb base as indicated by. Fold into puaters and fold middle sections into 1 ths. Notice alternation valley and mountain folds. No new folds in this diagram. Eneccessary folds have been removed. Beform waterbomb base and do a series of inside and outside reverse folds. Model should lie flat features in above diagram have been exaggerated to see features underneath. Fold corners and reverse Model should now look like this. With the second layer fold corners and then reverse Model Chi-Wing Fighter Page 1 of 5 Designer Wayne No__ Diagrammed 2y Winson Chan email Revision Date 0 23 9S Reverse fold the tip on top this. Next two steps will Re an enlargement of circled area Beverse fold the tip on either side. Notice the valley fold this edge should remain where it is do not fold inside Model should now look like this notice where the layers end up. Bepeat on backside View of the top of the model. Botate flaps to reveal the sides Valley fold half the layers do this only on one side Model should now look like this. Flip model over Model Chi-Wing Fighter Page 2 of 5 Designer Wayne No__ Diagrammed 2y Winson Chan Make mountain and valley creases as shown. @ush the sides in so that the top layer of paper as back end of the model rises. Model does not remain flat email Revision Date 0 23 9S Model should now look like this. A 3-4 view is shown on the right and a side view in step Side view. Flatten wing be folding along crease indicated The triangle forms the cockpit of the X-wing. Beverse fold along line bisect 45 degree angle indicated Bisect the 45 degree angle and tuck inside as shown. Bepeat on other side of the wing and on each wing. Model Chi-Wing Fighter Page 5 of 5 Designer Wayne Fo__ Diagrammed 2y Winson Chan email .