tailieunhanh - Bottle – using Surface Features

Tham khảo tài liệu 'bottle – using surface features', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | njtt ME-430 INTRODUCTION TO COMPUTER AIDED DESIGN Bottle - using Surface Features Pro ENGINEER Wildfire Dr. Herli Surjanhata Create a part named bottle with three default datum planes and default coordinate system. Make sure the Units is in millimeters. To change the units From Edit pull down menu select Setup - Units Select millimeter Newton Second mmNs . Set and select Interpret Existing Numbers Same Dims . Click the OK button. Close - Done Pick the icon to create a sketched datum curve on the FRONT datum plane. The dimensions for the datum curve shown in Figure below. 1 2 Edit View Insert Analysis Info Regenerate Mirror the datum curve about the RIGHT datum plane. Select the datum curve in the Model Tree or graphic area then choose Edit - Mirror Undo Redo Ctrl Z Ctrl Y Pick Right datum plane as Mirror plane Pick the button to complete the task. Repeat the same procedure to create another datum curve. Create a sketched datum curve as shown in the Figure below. Sketch on the RIGHT datum plane with TOP as the top reference. Make sure it is 140 mm height the same height as the other curve