tailieunhanh - PUMP HOUSING CREATED USING SURFACE Pro/ENGINEER

Select the CS0 coordinate system. Cylindrical – as the type of coordinate system. Editor window appears, and enter the following equation – see figure below: r = 5 + *t theta = -105 – 345*t z=0 Save and Exit the editor. Click OK to end the datum curve creation. | NUT ME-430 INTRODUCTION TO COMPUTER AIDED DESIGN PUMP HOUSING CREATED USING SURFACE Pro ENGINEER Wildfire Dr. Herli Surjanhata 1 Create a part called pump_housing. Delete the default coordinate system. Right-click on PRT_CSYS_DEF and select Delete. I IJ RIGHT 7 TOP n front FlFIT_CSï lEr Insert Here Delete Group Suppress Rename Move Datum Tag Pattern. Setup Note Info Hide Edit Parameters 2 Orient by Î J References selection O Selected CSYS axes Select the Orientation tab make sure that coordinate system CS0 as shown in the figure below. The X-Y plane of CS0 is aligned with RIGHT. OK Cancel Create the following datum curve. Click - Insert a datum curve icon then select From Equation - Done

TỪ KHÓA LIÊN QUAN