tailieunhanh - Nghệ thuật xếp hình Nhật Bản:mantis

Nghệ thuật xếp hình: mantis. Tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn. | Praying Mantis by Robert j Lang Copyright 1990. All rights reserved. i i 2. Fold and unfold. 3. First make the horizontal crease halfway between the two pinch marks. Then make the vertical crease through the intersection of the horizontal crease and the diagonal of the square. 4. Fold the corners in and turn 5. Fold a Waterbomb Base the paper over. based on the new creases. using the program Aldus FreeHand linked with additional PostScript routines that were coded by the author. The design and these drawings may not be distributed commercially. ra D 7. Fold and unfold. 8. Open-sink the corner. 10. Reverse-fold the corner. 9. Open out the sink and push some paper up from the inside pinch the excess paper in half and swing it over to the left. 11. Pull down the edge of the pocket and fold the right layer back to the left. 12. Fold one flap down. 15. Squash-fold. 13. Swing one layer from right to left. 14. Repeat steps 6-13 on the right. 16. Petal-fold. 17. Unwrap a single layer. 18. Squash-fold. 19. Reverse-fold the edges. 20. Turn the model over. 21. Repeat steps 15-17. 24. Reverse-fold a single 25. Reverse-fold layer out from the inside. 22. Fold and 23. Fold the flap down using the unfold. newly-made creases as a guide. 29. Flatten the edges. 26. Reversefold the bottom corner. 27. Pull out the layers trapped under the triangular hood. The model will not lie flat. 28. Open-sink the shaded region and refold. 30. Fold and 31. Fold one the sunk unfold. layer to the left region. in front and one to the right behind. 32. Top of the model. Fold and unfold. 33. Pleat and fold a rabbit ear from the thick point using the existing creases. 34. Fold and unfold through all layers. 35. Wrap one layer of paper to the front. 36. Fold one layer to the right releasing the trapped paper at the left that links it to 37. In progress. Pull paper out from here. 38. Close the model back up. 39. Repeat steps 36-38 on the next two layers. 40. Swing the point over to the left. the next