tailieunhanh - Nghệ thuật xếp hình Nhật Bản:pot_with_leaves_and_stem_2

Nghệ thuật xếp hình: pot_with_leaves_and_stem_2. Tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn. | Pot with Leaves and Stem by Kalei Anne Lundberg copyright 2001 This model was designed to make use of variegated paper. If you want to experiment with your own paper design either affix a square the color you would like the pot to be using acid-free glue stick or dye the paper following the coloring design. The diagrams are offered for personal use for any other use please contact me for permission at models@. 1500 2. Squash fold. Repeat on the back side. 1. Collapse into a colored preliminary fold. Turn model so free points are on the bottom. Coloring design side 3. Valley fold top flap to the right. Repeat on the back side. 8. Repeat steps 5 and 6. 6. Valley fold the small point downward. Repeat on the back side. 7. Valley fold the top two left hand flaps to the right and the back two right hand flaps to the left. Minor Miracle 9. Lilly Frog base Fold and unfold to mark then open sink the top point. 10. Inside reverse fold the small point to the inside of the model. 11. Valley fold one flap to the right. 12. Valley fold another flap to the right. 13. Repeat step 10. 14. There should be 3 free points on the bottom right and one on the bottom left. Valley fold one layer to the left. 15. Valley fold flap upward. Turn model over. 16. Valley fold one layer to the right. 17. Rotate model so the sink is at the bottom. Flower Pot page 2 of 4 http Notes I found that the easiest way to perform steps 18-22 was to do both sides at the same time. Because the hidden paper movement is beyond my diagramming capabilities the following instructs you to fold one side at a time. This works but is not the quickest method. Basically what needs to be done is to return the face of the lily base that will become the stem in the model back to a bird base form by pulling out the paper and spread squashing the sink folds of the lily frog base. The inside reverse fold in step 21 needs to be slipped behind the resulting triangular shaped sink fold dotted line in step 21