tailieunhanh - Nghệ thuật xếp hình Nhật Bản:pumpkin_2

Nghệ thuật xếp hình: pumpkin_2. Tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn. | Jan-O-Lantern by Kalei Anne Lundberg copyright 2000 This model is named for my sister-in-law who is a firm believer that there can never be too many Halloween decorations. It is best made of duo-colored paper but I have tested the design by using restickable glue stick to tack the outer edges of the eye color paper to orange tissue paper. There is some minor slippage in the swivel fold in step 8 along the eye side of the fold. A six inch piece of kami will make a model about inches tall without the stem. The diagrams are offered for personal use. For any other use please contact me for permission at pumpkin@. 1. Eye Color Up. Crease the center line. 2. Valley fold to the center. These folds should be make to butt very tightly together. 3. Fold and unfold to set the crease for the stem section. 5. Valley fold. 4. Valley fold to center. These folds could even overlap a little. Unfold left side. 6 Enlarged views shown without the stem section of the model. Pumpkin page 1 of 3 http 7. Swivel fold to form nose and narrow eyes. 8. Valley fold. Repeat steps 5-8 on the right side flap. 9. Inside reverse fold to the crease line made in step 3. 11. Squash fold. 10. Valley fold. The top edge should be parallel to the upper edge. 12. Petal fold the bottom portion of the squash fold while opening the top portion to lay flat. 13. Completed fold. Repeat on the other side. 14. Valley fold flap through the jaw folds. 15. Tuck the top portion of the lower mouth flap behind the eye flaps. Fold tip under. Pumpkin page 2 of 3 http 17. Open up the stem section and squash fold. 18. Valley fold the tip down. Valley fold the sides to the center. 16. Mountain fold the tip along the crease made in step 3. Turn model over 19. Squash fold the corners. 20. Rabbit ear the sides. The center fold of the rabbit ear will lay even with where the jaw flap meets the eye flap on the front side. This fold need not be flattened as it will be rolled back outward in