tailieunhanh - Popular Wood Working P3

Tham khảo tài liệu 'popular wood working p3', kỹ thuật - công nghệ, kiến trúc - xây dựng phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | I Can Do That -- CONTINUED FROM PACE 32 Hold it right there. Make a 45 cut in a thick scrap to use as a stop. This will hold the moulding securely as you make the miter cuts. Now place all four sides of the moulding against the tray bottom and check the fit. Tape each corner except one tightly around the edge with packing tape to form the four-sided moulding frame. Then open the corners and lay the taped side down. It will be a long strip of wood with open taped joints. Put a thin coat of glue on each of the miters and let it dry for about 10 minutes. The glue will soak into the short grain and form a slight coating. Add another thin coat of glue to the miters and press the first joint together making sure it fits together as it should. If there s any squeeze-out wipe it away with a wet rag. Work your way around each joint and when you ve glued the last one add tape to thatjointaswell. Check for squareness and when you re sure the joints are square add another piece of tape across each corner to hold it square as it dries. Let it dry for a few hours. Remove the tape from the corners and clean up any squeeze-out on the bottom side of the frame so it will lay perfectly flat on the tray. Do It Again This process is repeated for making the top moulding frame from the glass bead moulding. I chose the beaded edge to serve as the top edge thinking that it would stand up to use better than the thinner coved edge. Again cut Low-profile Serving Tray NO. ITEM 1 Tray bottom 4 Corner moulding frame 4 Glass bead moulding frame 4 Feet These measurements are longer than finished size. Cut miters to fit. theside pieces longerthan needed and cut the miter on one end of each of the long sides. Line up the miter of the top moulding with the beaded edge up with the mitered corner of the corner moulding frame. The bead will be the top edge of the tray. It s important to remember that the bead is the top when making the miter cuts. It s easy to get confident about the cuts and forget .