tailieunhanh - Study of the changes in composition of ammonium diuranate with progress of precipitation, and study of the properties of ammonium diuranate and its subsequent products produced from both uranyl nitrate and uranyl fluoride solutions

In present paper, ADU has been produced via both the routes. Variation of uranium recovery and crystal structure and composition of ADU with progress in precipitation reaction has been studied with special attention on first appearance of the precipitate Further, ADU produced by two routes have been calcined to UO3, then reduced to UO2 and hydroflorinated to UF4. Effect of two different process routes of ADU precipitation on the characteristics of ADU, UO3, UO2 and UF4 were studied here. | Study of the changes in composition of ammonium diuranate with progress of precipitation, and study of the properties of ammonium diuranate and its subsequent products produced from both uranyl nitrate and uranyl fluoride solutions N u c l e a r E n g i n e e r i n g a n d T e c h n o l o g y 4 9 ( 2 0 1 7 ) 5 4 1 e5 4 8 Available online at ScienceDirect Nuclear Engineering and Technology journal homepage: Original Article Study of the Changes in Composition of Ammonium Diuranate with Progress of Precipitation, and Study of the Properties of Ammonium Diuranate and its Subsequent Products Produced from both Uranyl Nitrate and Uranyl Fluoride Solutions Subhankar Manna a,b,*, Raj Kumar a, Santosh K. Satpati a, Saswati B. Roy a, and Jyeshtharaj B. Joshi b,c a Bhabha Atomic Research Centre, Trombay, Mumbai 400 085, India b Homi Bhabha National Institute (HBNI), Anushakti Nagar, Mumbai 400 094, India c Department of Chemical Engineering, Institute of Chemical Technology, Nathalal Parekh Marg, Matunga, Mumbai 400 019, India article info abstract Article history: Uranium metal used for fabrication of fuel for research reactors in India is generally Received 18 July 2016 produced by magnesio-thermic reduction of UF4. Performance of magnesio-thermic re- Received in revised form action and recovery and quality of uranium largely depends on properties of UF4. As 20 September 2016 ammonium diuranate (ADU) is first product in powder form in the process flow-sheet, Accepted 21 September 2016 properties of UF4 depend on properties of ADU. ADU is generally produced from uranyl Available online 14 October 2016 nitrate solution (UNS) for natural uranium metal production and from uranyl fluoride solution (UFS) for low enriched uranium metal production. In present paper, ADU has been Keywords: produced via both the routes. Variation of uranium recovery and crystal structure and Ammonium diuranate .

• Kỹ Thuật - Công Nghệ
• Nuclear engineering and technology
• Study of the changes in composition of ammonium diuranate
• Progress of precipitation
• Ammonium diuranate and its subsequent products produced
• Both uranyl nitrate and uranyl fluoride solutions
• Integral nuclear data validation
• Experimental spent nuclear fuel compositions
• Economic Co operation and Development
• Nuclear Energy Agency
• Nuclear Criticality Safety
• Expanded spent fuel isotopic compositions
• Nuclear reactor vessel water level prediction during severe accidents
• Deep neural networks
• Nuclear power plants
• Maintain nuclear reactor integrity
• Special issue on the International Symposium
• Future Instrumentation and Control for Nuclear Power Plants
• The Nuclear Engineering and Technolog
• Parameter identifiability of Boolean networks
• Application to fault diagnosis of nuclear plants
• Fault diagnosis of nuclear plants
• Nuclear Heating Reactor
• Sensor selection strategy
• Radioactive effluents released from Korean nuclear power plants
• The resulting radiation doses to members of the public
• Korean nuclear power plants
• Nuclear power plant
• The recycling of nuclear graphite after micro oxidation
• Nuclear graphite after micro oxidation
• Whether ground micro oxidation graphite
• The oxidized graphite particles
• The recycling of nuclear graphite
• Statistical model for forecasting uranium prices
• Estimate the nuclear fuel cycle cost
• Nuclear Fuel Cycle Cost
• Nuclear fuel cycle cost calculation
• The statistical autoregressive integrated moving average
• Distinct properties of tungsten austenitic stainless alloy
• Potential nuclear engineering material
• Interchanging the molybdenum in standard SS316 by tungsten
• Gamma and neutron shielding Interchanging the molybdenum
• Nuclear engineering and design
• Brayton cycle
• Supercritical carbon dioxide
• Nuclear engineering
• Safety analysis
• Control strategy
• Seismic fragility evaluation
• The base isolated nuclear power plant piping system
• The failure criterion based on stress strain
• Nuclear power plant piping system
• Seismic fragility analysis
• BNL NRC benchmark model
• Feasibility study on photo production
• 99mTc with the nuclear resonance fluorescence
• The nuclear resonance fluorescence
• High intensity laser Compton scattering
• Improved PCA method
• Sensor fault detection and isolation in a nuclear power plant
• Sensor fault detection and isolation
• Influences of heating processes on properties
• Microstructure of porous CeO2 beads
• Surrogate for nuclear fuels fabricated
• Microfluidic sol gel process
• The ceramic nuclear fuel particles
• Sensitivity analysis of thermal hydraulic parameters
• The corrosion intensity in nuclear power plant steam generators
• Nuclear power plant steam generators
• The failure of steam generators
• The heat exchangers
• Architectural model driven dependability analysis
• Computer based safety system in nuclear power plant
• Safety system in nuclear power plant
• Embedded Real Time Safety Systems
• Mitigation of high energy arcing faults
• Nuclear power plant medium voltage switchgear
• High energy arcing fault
• Ultra high performance fiber reinforced concrete nuclear waste container
• High level waste
• Ultra high performance fiber reinforced concrete material
• The dry storage container
• Canadian Nuclear facilities
• Real time estimation of break sizes during LOCA
• Nuclear power plants using NARX neural network
• Nonlinear autoregressive with exogenous inputs
• Loss of coolant accidents
• Nordic research and development cooperation
• Strengthen nuclear reactor safety after the Fukushima accident
• The Fukushima accident
• Nordic Nuclear Safety Research
• Seismic response characteristics
• Isolated AP1000 nuclear shield building subjected
• Beyond design basis earthquake shaking
• Beyond Design Basis Earthquake
• Nuclear Shield Building
• Uncertainty analysis of containment dose rate
• Containment dose rate for core damage assessment
• Containment Radiation Monitor
• Core Damage Assessment
• An evaluation method for nuclear fuel debrisefiltering performance
• Nuclear fuel debrisefiltering performance
• Comprehensive Debris Filtering Efficiency
• Debris Filtering Performance
• Debris Induced Failure
• Development of earthquake instrumentation for shutdown
• Restart criteria of the nuclear power plant
• Multivariable decision making process
• The nuclear power plant
• Development of an information reference system
• Reconstruction models of nuclear power plants
• Work site reconstruction models
• Six nuclear power plant workers
• Nondestructive inspection of spent nuclear fuel storage canisters
• Shear horizontal guided waves
• Spent nuclear fuel storage canisters
• The cask protecting the canister
• Geometric constrains inside