tailieunhanh - Force and stress analysis at the linkage points of the mini lifting device by adams view and inventor software

The paper presents the results of calculating the stress concentration at the link points by the method of separation of nodes in terms of conditions and load bearing design allowed. The study also shows the results of calculation after the test and the aggregation of forces in accordance with the links at the elements that need to be considered and given in the problem. | ISSN 1859-1531 - TẠP CHÍ KHOA HỌC VÀ CÔNG NGHỆ ĐẠI HỌC ĐÀ NẴNG, VOL. 17, NO. , 2019 65 FORCE AND STRESS ANALYSIS AT THE LINKAGE POINTS OF THE MINI LIFTING DEVICE BY ADAMS/VIEW AND INVENTOR SOFTWARE PHÂN TÍCH LỰC VÀ ỨNG SUẤT TẠI CÁC ĐIỂM LIÊN KẾT CỦA THIẾT BỊ NÂNG MINI BẰNG PHẦN MỀM ADAMS/VIEW VÀ INVENTOR Nguyen Thi Hai Van*, Nguyen Le Van, Nguyen Thai Duong The University of Danang, University of Technology and Education; haivanbk2010@ Abstract - Rotary joints, bearings, rollers, connectors, etc are details that connect the axes together which are loaded equally or unequally. Building the strength calculation in combination with simulating the distribution of stresses in the use of allowable loads is a necessary and practical element for the active time of machine. Based on the theoretical calculations after model and layout survey, the paper presents the results of calculating the stress concentration at the link points by the method of separation of nodes in terms of conditions and load bearing design allowed. The study also shows the results of calculation after the test and the aggregation of forces in accordance with the links at the elements that need to be considered and given in the problem. These results are compared with those stimulated and calculated by Adams/View and Inventor softwares. Tóm tắt - Khớp quay, bạc đỡ, con lăn là các chi tiết kết nối các thanh lại với nhau và chịu tác dụng của tải trọng có thể đều hoặc không đều. Việc xây dựng bài toán tính toán sức bền kết hợp với mô phỏng việc phân bố các ứng suất trong việc sử dụng tải trọng cho phép là một yếu tố cần thiết và mang tính thiết thực trong suốt thời gian hoạt động. Trên cơ sở xây dựng lý thuyết tính toán sau khi khảo sát mô hình và cách bố trí, bài báo đã thể ện kết quả tính toán sự tập trung ứng suất tại các điểm liên kết bằng phương pháp tách nút trong điều kiện và phương án thiết kế chịu tải cho phép. Nghiên cứu cũng đã thể hiện rõ kết quả tính toán sau khi kiểm nghiệm .