tailieunhanh - Investigating sampling accuracy to estimate sediment concentrations in erosion plot tanks

Significant errors when sampling from collection tanks installed at the lower end of soil erosion plots may lead researchers toward wrong conclusions. Limited research has been found on sampling accuracy. In this study, a cylindrical sampler is introduced as a new sampling device and its sampling accuracy is investigated and compared with 2 other manual methods, namely bottle and pipette. | D. NIKKAMI Research Article Turk J Agric For 36 (2012) 583-590 © TÜBİTAK doi: Investigating sampling accuracy to estimate sediment concentrations in erosion plot tanks Davood NIKKAMI* Department of Soil and Water Conservation, Soil Conservation and Watershed Management Research Institute (SCWMRI), . Box 13445-1136, Tehran - IRAN Received: ● Accepted: Abstract: Significant errors when sampling from collection tanks installed at the lower end of soil erosion plots may lead researchers toward wrong conclusions. Limited research has been found on sampling accuracy. In this study, a cylindrical sampler is introduced as a new sampling device and its sampling accuracy is investigated and compared with 2 other manual methods, namely bottle and pipette. Three target sediment concentrations were prepared in separate collection tanks as 3 replications with 3 mixing periods. The results using the bottle and pipette in all mixing periods and all target sediment concentrations showed that the concentration of sediment increases with the depth of the tank, which implies that making a uniform sediment concentration in the collection tank for sampling is impossible. The results indicated that the cylindrical sampler had the highest sampling efficiency of . Computed sampling efficiencies in tanks of 20, 40, 60, and 80 cm in depth were , , , and for the bottle and , , , and for the pipette, respectively. There was no significant difference between sampling from the center and from the side of the collection tank and among mixing periods of 1, 2, and 5 min. In order to maximize the accuracy of the sampling, a 10-L bucket was placed in the collection tank to trap the coarse material. Weighing collected coarse material and adding the sampled part improved the accuracy by . In fact, using a cylindrical sampler and a bucket together resulted in sampling .