tailieunhanh - On a programme for the balancing calculation of flexible rotors with the influence coefficient method

This paper presents the influence coefficient method of determining the locations of unbalances on a flexible rotor system and the correction weights. A computer software for calculating the at-the-site balancing of a flexible rotor systern was created using c++ language at the Hanoi University of Technology. This software can be used by balancing flexible rotors in Vietnam. | Vietnam Journal of Mechanics, NCST of Vietnam Vol. 22, 2000, No 4 (235 - 247) ON A PROGRAMME FOR THE BALANCING CALCULATION OF FLEXIBLE ROTORS WITH THE INFLUENCE COEFFICIENT METHOD NGUYEN VAN KHANG - TRAN VAN LUONG Hanoi University of Technology ABSTRACT. This paper presents the influence coefficient method of determining the locations of unbalances on a flexible rotor system and the correction weights. A computer software for calculating the at-the-site balancing of a flexible rotor was created using c++ language at the Hanoi University of Technology. This software can be used by balancing flexible rotors in Vietnam. 1. Introduction The well-known methods of the at-the-site balancing of flexible rotors (the method of three time starting the trial weights, the vector triangle, the sensitivity) were successfully used to balance separate flexible rotors at the site. However, the efficiency of these balancing methods depends a lot on the correctness of the analysis of the vibration modes of separate rotors. Nowadays, rotors are manufactured longer and longer, many rotors are connected with each other. After manufacture, rotors are separately balanced before leaving the production workshop, but by connecting many rotors together, the separate balance status disappears due to mutual interaction of the residual unbalance remaining in each rotor which causes changes in the vibration of the entire system. The methods of separate rotor balancing may reduce vibration of the balanced rotor, but may increase vibration in many points in the other rotors of the system. In order to work safely, the vibration rate in all points of the rotor system, in all regimes, must lie within the permitted standards. Therefore the entire system of rotors must be balanced. In this paper, the author present the influence coefficient method for balancing flexible rotors [1, 2, 3]. This method is dependent on the basic principle that the influence coefficient matrix is square. In .

• Tự động hoá
• Vietnam Journal of Mechanics
• The balancing calculation of flexible rotors
• The influence coefficient method
• The correction weights
• Flexible rotor systern
• Dang Dinh Ang
• Nonlinear analysis and mechanics
• Dynamic problems involving stationary cracks
• The Wiener Hopt technique
• Dual integral equations
• Dual integrals in non linear fracture mechanics
• Non linear fracture mechanics
• Energy release rate
• Discuss the obtained
• The alpha finite element method (αFEM)
• Solid mechanics using triangular and tetrahedral elements
• Suitable computational cost
• NS FEM makes
• The upper bound property
• Non linear constitutive problems in solid mechanics
• Non linear constitutive problems
• Languages Gibian and special operators
• The application FEM
• Betts miller janjic convective parameterization scheme
• H14 31 model to forecast heavy rainfall in Vietnam
• Betts Miller Janjic
• Three rain seasons
• Manufacturing dry mixed cement mortar
• High compressive strength
• High flexural strength
• Low shrinkage and high watertightness for restoration
• Damaged hydraulic structures in Vietnam
• Standard gradient models and crack simulation
• Standard gradient models
• The propagation of cracks
• Damage mechanics and crack simulation
• The interaction between two parametric excitations
• The second and third degrees
• The asymptotic method of nonlinear mechanics
• Dynamic system governed
• Comparison of two hydrological model simulations
• Nam and Xinanjiang for Nong Son catchment
• The Central Vietnam
• The runoff components
• 3 D numerical simulation
• The tidal circulation
• The gulf of Tonkin
• The kinetic energy distribution
• Duality in the analysis of responses to nonlinear systems
• The analysis of responses
• The original nonlinear systems
• The study of nonlinear mechanics
• Aerodynamics of a wing in surface effect ship
• Theory and experiment
• Wing in surface effect ship
• The aerodynamic characteristics
• The Institute of Mechanics
• The error estimate
• The convergence rate for h
• p refinement
• The finite element analysis
• Three dimensional elastostatic mechanics problems
• Some initial experimental results
• Free water layer formation in horizontal pipes
• Water layer formation
• Hanoi Institute of Mechanics
• Bending vibration of beam elements under moving loads
• Considering vehicle braking forces
• Fluctuations of structures
• Beam elements according
• Continuous element for vibration analysis
• Thick shells of revolution
• Continous Element Method
• Finite element solutions
• Natural frequencies and harmonic responses
• Cast3m implementation of the extended finite element method
• The extended finite element method for cohesive crack
• Quasi brittle materia
• The proposed implementation
• The displacement discontinuities
• Buckling analysis of simply supported composite laminates subjected
• In plane compression load
• A novel mesh ffree method
• Alternative numerical technique
• Mesh free method
• A three story building
• Hedge algebras based fuzzy controller
• The structural system
• The El Centro earthquake
• Three story building against earthquake
• Laminar separation phenomenon combining with numerical calculations
• The turbulent separation
• The laminar separation
• Experimental study on mechanical properties
• Three phase polymer composite reinforced
• Glass fibers and titanium oxide particles
• Polymer composite reinforced
• Three phase composite
• Dynamic characteristics of elastically supported beam subjected
• A compressive axial force and a moving load
• The implicit Newmark method
• The Galerkin finite element method
• The axial force
• Eccentrically stiffened functionally graded plates and shallow shells
• Von Karman Donnell sense
• The formulation of governing equations
• The classical shell theory
• Mathematical modelling and control of the evolution
• Dynamic systems interacting with medium
• Mathematical modeling evolutional systems interacting
• Two conjugate mechanical subsystems
• Evaluating structural safety based on fuzzy set theory
• Evaluating structural safety
• The fuzzy reliability
• Simple beam structure