Kinh doanh - Marketing
Kinh tế quản lý
Biểu mẫu - Văn bản
Tài chính - Ngân hàng
Công nghệ thông tin
Tiếng anh ngoại ngữ
Kĩ thuật công nghệ
Khoa học tự nhiên
Khoa học xã hội
Văn hóa nghệ thuật
Sức khỏe - Y tế
Văn bản luật
Nông Lâm Ngư
Kỹ năng mềm
Luận văn - Báo cáo
Giải trí - Thư giãn
Tài liệu phổ thông
Văn mẫu
Giới thiệu
Đăng ký
Đăng nhập
Tìm
Danh mục
Kinh doanh - Marketing
Kinh tế quản lý
Biểu mẫu - Văn bản
Tài chính - Ngân hàng
Công nghệ thông tin
Tiếng anh ngoại ngữ
Kĩ thuật công nghệ
Khoa học tự nhiên
Khoa học xã hội
Văn hóa nghệ thuật
Y tế sức khỏe
Văn bản luật
Nông lâm ngư
Kĩ năng mềm
Luận văn - Báo cáo
Giải trí - Thư giãn
Tài liệu phổ thông
Văn mẫu
Thông tin
Điều khoản sử dụng
Quy định bảo mật
Quy chế hoạt động
Chính sách bản quyền
Giới thiệu
Đăng ký
Đăng nhập
0
Trang chủ
Kỹ Thuật - Công Nghệ
Cơ khí - Chế tạo máy
Handbook Corrosion (1992) WW Part 3
Đang chuẩn bị liên kết để tải về tài liệu:
Handbook Corrosion (1992) WW Part 3
Diễm Uyên
89
250
pdf
Đang chuẩn bị nút TẢI XUỐNG, xin hãy chờ
Tải xuống
Tham khảo tài liệu 'handbook corrosion (1992) ww part 3', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | Table 3 Planned interval corrosion test 3 Duplicate strips of low-carbon steel 19 X 75 mm or I X 3 in. were immersed in 200 mL of 10 AlCl3-90 SbCl3 mixture through which dried hydrogen chloride gas was slowly bubbled at atmospheric pressure. Temperature 90 C 195 F Value Interval days Weight loss mg Penetration Apparent corrosion rate Pm mils mm yr mils yr A1 0-1 1080 42.9 1.69 15.7 620 At 0-3 1430 56.9 2.24 6.8 270 At 1 0-4 1460 58.2 2.29 5.3 210 B 3-4 70 2.8 0.11 1.02 40 A2 calculated 3-4 30 1.3 0.05 0.46 18 A2 B A1 0.05 0.11 1.69 Conclusions Liquid markedly decreased in corrosiveness during the test and the formation of a partially protective scale on the steel was indicated that is metal became less corrodible. The causes for the changes in corrosion rate as a function of time are not given by the planned interval test criteria. The corrosivity of the liquid may decrease as a result of corrosion during the course of a test because of the reduction in concentration of the corrosive agent the depletion of a corrosive contaminant the formation of inhibiting products or other metal-catalyzed changes in the liquid. The corrosivity of the liquid may increase because of the formation of autocatalytic products the destruction of corrosion-inhibiting substances or other catalyzed changes in the liquid. Changes in the corrosiveness of the liquid may also arise from changes in composition that would occur under the test conditions even in the absence of metal. To determine if the latter effect occurs an identical test is run without test strips for the total time t. Test strips are then added and the test is continued for unit time interval. Comparison with A1 of corrosion damage from this test shows if the corrosive character of the liquid changes significantly in the absence of metal. The corrodibility of the metal in a test may decrease as a function of time because of the formation of protective scale or the removal of a less resistant surface layer of metal. Metal .
TÀI LIỆU LIÊN QUAN
crossorigin="anonymous">
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.