Kinh doanh - Marketing
Kinh tế quản lý
Biểu mẫu - Văn bản
Tài chính - Ngân hàng
Công nghệ thông tin
Tiếng anh ngoại ngữ
Kĩ thuật công nghệ
Khoa học tự nhiên
Khoa học xã hội
Văn hóa nghệ thuật
Sức khỏe - Y tế
Văn bản luật
Nông Lâm Ngư
Kỹ năng mềm
Luận văn - Báo cáo
Giải trí - Thư giãn
Tài liệu phổ thông
Văn mẫu
Giới thiệu
Đăng ký
Đăng nhập
Tìm
Danh mục
Kinh doanh - Marketing
Kinh tế quản lý
Biểu mẫu - Văn bản
Tài chính - Ngân hàng
Công nghệ thông tin
Tiếng anh ngoại ngữ
Kĩ thuật công nghệ
Khoa học tự nhiên
Khoa học xã hội
Văn hóa nghệ thuật
Y tế sức khỏe
Văn bản luật
Nông lâm ngư
Kĩ năng mềm
Luận văn - Báo cáo
Giải trí - Thư giãn
Tài liệu phổ thông
Văn mẫu
Thông tin
Điều khoản sử dụng
Quy định bảo mật
Quy chế hoạt động
Chính sách bản quyền
Giới thiệu
Đăng ký
Đăng nhập
0
Trang chủ
Kỹ Thuật - Công Nghệ
Cơ khí - Chế tạo máy
Wind_Farm Technical Regulations Potential Estimation and Siting Assessment Part 2
Đang chuẩn bị liên kết để tải về tài liệu:
Wind_Farm Technical Regulations Potential Estimation and Siting Assessment Part 2
Xuân Hiếu
89
20
pdf
Đang chuẩn bị nút TẢI XUỐNG, xin hãy chờ
Tải xuống
Tham khảo tài liệu 'wind_farm technical regulations potential estimation and siting assessment part 2', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | Technical and Regulatory Exigencies for Grid Connection of Wind Generation 9 turbines are destroyed is in the range of 40-72 m s 144-259 km h or 89-161 mph . The most common survival speed of commercial wind turbines is around 60 m s 216 km h or 134 mph . Wind turbines have three modes of operation Hansen et al. 2004 . Below rated wind speed operation Around rated wind speed operation usually at nominal capacity Above rated wind speed operation If the rated wind speed is exceeded the power has to be limited. Therefore all wind turbines are designed with a power control that achieves this goal and avoids a run-away situation. There are different ways of doing this safely on modern turbines namely mainly pitch control and stall control. 3.2.3.1 Pitch control This control concept was developed between years 1990 and 2000 and operates by turning the rotor blades into or out of the wind according to the control laws. An anemometer mounted atop the nacelle constantly checks the wind speed and sends signals to the pitch actuator adjusting the angle of the blades to capture the energy from the wind most efficiently. Standard modern turbines usually pitch the blades at high winds in order to prevent the rotational speed from rising to an unacceptably dangerous level. Since pitching requires acting against the torque on the blade it requires some form of pitch angle control which is achieved with a slewing drive. This drive precisely angles the blade while withstanding high torque loads. In addition many turbines use hydraulic systems. These systems are usually spring loaded so that if hydraulic power fails the blades automatically furl. Other turbines use an electric servomotor for every rotor blade. They have a small battery-reserve in case of an electric grid breakdown. Small wind turbines fewer than some kWs with variable pitching generally use systems operated by centrifugal force either by flyweights or geometric design and employ no electric or hydraulic controls. In
TÀI LIỆU LIÊN QUAN
The Wind Energy Handbook
Wind Energy Handbook
MagLev Wind Turbine Technologies, Inc. (MWTT) & Off Grid Technologies, Inc. (OGT) Vertical Axis Wind Turbine 200 Mega Watt Off Shore Wind Farm (VAWT Off Shore JV)
An analysis towards a sustainable energy system in albania highly supported by large scale integration of wind resources: A case study of Mamaj wind farm
Stability evaluation of a large scale offshore wind farm integrated into a power system via an HVDC link and an HVAC line
Wind farm layout optimization considering wake effect
Economic Assessment of Puketoi Wind Farm
Wind Farm Impact in Power System and Alternatives to Improve the Integration Part 1
Wind Farm Impact in Power System and Alternatives to Improve the Integration Part 2
Wind Farm Impact in Power System and Alternatives to Improve the Integration Part 3
crossorigin="anonymous">
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.